Mechanical permanent anchor pad/plate EN 795 class A ref. AT180

CHARACTERISTICS

• Cancamo / Mechanical permanent anchorage plate for M12 bolt made of ANSI 316 stainless steel.
• Valid for one person.
• Static resistance: at least 12 kN.
• Measures 56x56x50 mm .
• The hole diameter is 12,5 mm.
• Anchorage length 120 mm.
• In the case of vehicles of categories M1 and N2.

TECHNICAL DATA

• HSA-R M12x120 / 25/4
• length of anchorage - 120 mm
• Type of anchorage - mechanical anchorage
• Material: Stainless steel
• Prof. standard mounting - 70 mm
• The test shall be carried out in accordance with the procedure described in Appendix 2 to this annex

------------------------------------------------------

The work at height they involve a large number of risks and dangers to the health and wellbeing of workers, who must be Personal protective equipment appropriate to enable them to perform their duties with the greatest possible degree of safety. For work at height, not only those carried out at a height of more than two metres above the surface are considered, but also those carried out in excavations, ditches, wells other i want it to be effective. One of these important elements in a lot of work at height it's them anchorage points, as in the case of Mechanical permanent anchorage plate EN 795 class A ref. AT180.

The Mechanical permanent anchorage plate EN 795 class A ref. AT180 is an M21 bolt anchorage point made of stainless steel and intended for one person, with a minimum static resistance of 12 kN. Its dimensions are 56 x 56 x 50 mm, with a hole diameter of 12,5 mm and an anchorage length of 120 mm.

This type of anchorage device is designed to be part of the system that must be used in all these areas of work to be able to stop falls, serving as a junction point between harnesses, ropes, retractable anti-fall ... and the structure to which it is fixed. This type of anchorage is permanent, which makes it a solution designed to be placed in all those buildings where maintenance or periodic work is carried out. In any case, such elements should be checked according to the manufacturer's instructions to ensure that they are always in perfect condition for use by workers without endangering their use.

Anchorage devices shall be subject to a series of fall tests in all intended directions of use and shall be installed by qualified personnel to ensure their effectiveness. This anchorage point complies with EN 795, being one of the best options available on the market.