OPTIturn TX6222 400V precision lathe

Precision lathe with heavy spindle meeting the most stringent technical requirements.With digital position indicator NEWALL DP 700.
INDUSTRIAL SERIES.

· The machine bench and frame are cast.
· One-piece foundry.
· High degree of stiffness of the spindle rod casing due to the sharp ribbing made of 25GG casting material.
· All steel gears, hardened and polished.
· axles on needle bearings, all components lubricated in oil bath.
· The hardened and grinding shaft ensures high degrees of precision and durability.
· Toughened and rectified guides.
Main axle with electronic brake. · Electronic power shutdown of the Z-axis.
· All electronic controls are accessible.
· Fully illuminated work area.
· External refrigerant tank with fill level indicator.
· Full feed and covered spindle cap.
· Three-claw plate included.
· Ø 105 mm spindle through hole.
· SWH 7-C quick-change tool holders.
· Support for tools 32 x 130 type D for square blades.

Digital position display DP 700· Two Microsyn measuring rods and one Spherosyn, resistant to dirt.
· Intuitive and easy to use user interface.
· Developed and manufactured in England.
• IP67 rating.
· 5 years warranty for display and reading units.

Electrical box· 24 V power supply.
All contactors and relays Siemens or Schneider.

Model TX 6222
Manufacture from materials of any heading
Power of the engine 10 hp / 7,5 kW / 400 V
Point height 310 mm
Maximum distance between points 2.220 mm
Ø maximum on bench 620 mm
Ø maximum on trolley 424 mm
Width of bench 350 mm
Spindle speed range 40 - 1.650 r.p.m.
Number of gears 12
Morse code of the main spindle Ø 113 mm (1:20)
For the purpose of this Regulation, the following definitions shall apply:
Ø of the 105 mm rodhead spindle
Toured car portah. (charriot) 170 mm
Transverse wagon travel 350 mm
In the case of vehicles of categories M1 and N2 with a maximum mass not exceeding 2000 kg:.
In the case of vehicles of categories M1 and N1 with a maximum mass exceeding 2000 kg, the maximum mass of the vehicle shall not exceed 2000 kg.
Morse code of counterpoint MT 5
For the purpose of this Regulation, the following definitions shall apply:
Dimensions (l x an x al) 3.550 x 1.200 x 1.830 mm
Net weight 2,800 kg

INCLUDES AS STANDARD:
3 claw plate of Ø 315 mm camlock no. 8, reduction cap MT 7 / MT 5, fixed counterpoint MT 5 long, fixed counterpoint MT 5 short, operating tools, initial load with high quality oil.
for use in the manufacture of motor vehicles [1] 32 x 150 type D for square blades.