IRUDEK Expert Pro 100 Safety Harness with Positioning Belt

Harness with 1 dorsal anchorage point and extension belt + 1 sternal anchorage point + 180o rotary position belt with 2 “D” side rings and tool-hold rings. Adjustable on shoulders and thighs. Chest strap, shoulder strap, pelvic band and padded legs.

Forged aluminum rings. It comes in a nylon bag.

CHARACTERISTICS

• Other, of circular cross-section
• Textile external anchorage point
• Extension tape
• Shoulder strap
• Positioning belt
• Expert 3D rotary 180 or with 2 "D" rings for positioning
• Adjustable on shoulders and thighs

TECHNICAL DATA

• Weight:
• Capacity of use: 140 kg
• The belt: Expert 3D 180 or
• For the purpose of this Regulation, the following definitions shall apply:
• Antislip system: Yes
• Automatic buckles: Yes
• Tape width: 44 mm
• Size: S-M. L-XXL

PACKAGING DATA

• Weight:
• Unit/box: 5
• Packing length: 43 cm
• Packing width: 30 cm
• Height of packaging: 13 cm

MATERIALS

• Tape: polyester
• Manufacture from materials of any heading
• Rings: black galvanized steel
• Other bars and rods of stainless steel

SIZE GUIDE

*Measurements in centimetres

* Approximate measures

STANDARDS AND REGULATIONS

Meets the requirements of the Personal Protective Equipment (PPE) Directive

- IN 361

- IN 358

APPLICATIONS

For work at height

Suspension and positioning

RESTRICTIONS ON USE

The equipment must be attributed individually to one person.

- It is recommended that the anchorage point where the anti-fall system will be fixed be above the user. The anchorage point shall have a minimum static resistance of 12 kN (metal) or 18 kN (textile) and shall comply with the requirements of EN 795:1996 / EN 795:2012.

- Personal protective equipment should not be worn by persons whose state of health could affect the safety of the user under normal conditions of use or in an emergency.

- Personal protective equipment should only be used by a person trained and competent in its safe use.

ATTENTION

- A fall harness is the only acceptable body restraint that can be used in a fall harness.

- The fallprotection system must be connected only to the harness connection points marked with the capital letter “A”. The identification A/2 indicates that it is necessary to connect two connection points with the same identification. It is forbidden to connect the protective system to a single connection point identified as A/2”.

- In harnesses with a built-in belt, the positioning equipment must be connected only to the belt's lateral anchorage rings.

- Connection to the anchorage point and to other equipment must be made via muskets in accordance with EN362:2004.

- For use with EN 353-1:2014+A1:2017,EN 353-2:2002 it is recommended to connect the equipment to the front anchorage of the harness. For use with EN 355 energy absorbers or EN 360 anti-roll, it is recommended to connect the equipment to the harness dorsal anchorage point. - Before each use of personal protective equipment, it must be checked carefully to ensure that it is in working order and functioning properly.

- During the pre-use check it is necessary to carefully inspect all equipment elements to verify that they show no signs of deterioration, excessive wear, corrosion, abrasion, degradation by UV radiation, cutting or incorrect use. Pay particular attention to tapes, seams, anchor rings, buckles and deregulation elements.

ABOUT IRUDEK

Irudek Group is an expanding group of companies with headquarters in Spain, operations in Italy, Brazil and India and sells its products in more than 50 countries. Irudek Group is safety and guarantee, backed by years of experience and by customers who have placed their trust in its products.