GoPro iM2050GP2 Case

This is the iM2050GP2.

• Two pins with lock lock
• Sturdy hinges
• Light HPX® resin
• Capacity for 2 GoPro® cameras and their accessories
• Other, not further worked than hot-rolled
• In the case of vehicles of categories M1 and N2
• Comply with hand luggage regulations of a selection of airlines*
• Pond
• Two push and pull closures
• Limited lifetime warranty**
• **Lifetime guarantee not applicable in countries where legislation does not allow it
• *Check with your airline for exact requirements on measures

• INTERIOR
  it's 9.50" by 7.50" by 4.25" (24.1 x 19.1 x 10.8 cm)
• OUTSIDE
  it's 11.80" by 9.80" by 4.7030 x 24.9 x 11.9 cm)

• body: Injection Molded HPX® high performance resin
• close: Valox - Polybutylene Terephthalate (PBT) and its salts
• LATCH (ALT): Xenoy - Polyester/Polycarbonate blend
• of a kind used in motor vehicles OF WHICH:
• with: Stainless Steel
• PINS (ALT): Aluminium
• foam: manufacture from materials of any heading
• clearing body: Valox - Polybutylene Terephthalate (PBT) and its salts
• PURGE BODY (ALT): Xenoy - Polyester/Polycarbonate blend
• compensating vent: Gortex membrane
• offset ring: Buna-N, 50-60 Durometer Shore A
• depth of cover: one and a half inches
• base depth: two and a half inches
• total depth: it's 4.25" (10.8 cm)
• of which: manufacture from materials of any heading, except that of the product
• foam weight: i'm not going to tell you
• weight without foam: for use in the manufacture of motor vehicles
• floating capacity: 11.10 lbs (5 kg)
• the minimum temperature: -20° F (-29° C)
• the maximum temperature: FOR THE PURPOSES OF THIS ANNEX:
• CERTIFICATION: FOR THE PURPOSES OF THIS REGULATION, THE FOLLOWING DEFINITIONS SHALL APPLY: