WELDAS cotton coated glove for handling MIG guns

Welding glove with straight and reinforced thumb, for better handling of MIG pistols, in cowskin.

CHARACTERISTICS

• Serrated cowback skin.
• Full inner lining with cotton.
• A straight thumb helps the user handle a MIG pistol much better.
• Size L also available in 18 (46 cm.)
• Size L and XL also available left hand only in pairs (LH).

MATERIALS

In top quality cow leather, inner face of the shoulder, inner cotton lining, sewn with 3-layer KEVLAR® thread.

APPLICATIONS

Gloves for welding work.

OTHER

S (7 1/2) 35 CM.

I (9) 35 CM.

XL (9 1/2) 35 CM IN LENGTH.

20 INCHES BY 46 INCHES.

I'M GOING TO TELL YOU.

IN THE CASE OF VEHICLES OF CATEGORIES M1 AND N2.

THE TEST SHALL BE CARRIED OUT IN ACCORDANCE WITH THE FOLLOWING PROCEDURE:.

L/18 (9) 35 CM.

PACKAGING AND STORAGE

1 ud (the pair)

Store and dry above 5oC. Do not store more than 5 layers of cages on a pallet.

INSTRUCTIONS FOR USE

This glove is designed to be used as a welding glove for MIG/MAG as well as for electrode welding. There is currently no standardized test method for detecting lightning penetration U.V. however, current methods of constructing protective gloves for welders do not normally allow radiation penetration U.V.

With arc welding systems, it is not possible to protect all parts conducting the weld voltage from direct contact for operational reasons. The service life depends on the degree of wear and the intensity of use in the respective application areas. Therefore, temporary information is not possible. This glove should not be worn when there is a risk of entanglement by moving parts of machinery.

HEALTH INFORMATION

The pH, chromium VI and PCP levels of all materials have been checked and comply with EC standards, colouring based on natural materials.

STANDARDS AND STANDARDS

Thermal hazards: IN 12477 (2001+A1:2005) TYPE A - 41324 X

OF WHICH:

This Regulation shall be binding in its entirety and directly applicable in all Member States

Mechanical hazards: In the case of vehicles of categories M1 and N2- 3243 X

Electrical hazard: When the gloves are intended for arc welding: these gloves do not provide protection against electric shock caused by faulty equipment or live work, and electrical resistance is reduced if the gloves are wet, dirty or soaked in sweat, this could increase the risk.

ABOUT WELDS

The products developed by Weldas® with their quality control supported by field testing, have gained a reputation for high quality and best innovation worldwide for welding gloves and protective clothing. All products of Weldas® are guaranteed against manufacturing defects.